Bitkov

Vladimir Viktorovitch

Institute Laboratory
Date of birth: 20 December 1948
Institute: Institute of engineering science, Ural Branch of Rus.Ac.of Sci
Subdivision: System Simulation Laboratory
Position: Senjor research scientist
Degree: Candidate of engineering science (Doctor of Philosophy)
Official telephone number: (343) 351-47-71
Address for correspondence: 620219, Ekaterinburg, 91, Pervomayskaya str.
E-mail: ges@imach.intec.ru
Biography : Bitkov Vladimir V., born in 1948, a metallurgical engineer. In 1972 he graduated from Ural Polytechnical Institute, metallurgical faculty, specialty "Metal processing by pressure". Post-graduate study by correspondence from 1975 to 1978. From 1975 to 1986 - Head of Technical control department at Revda Hardware Metallurgical Plant. In 1978 - Ph.D. thesis defense, subject "Improvement of wire drawing technology on the basis of friction conditions and metal plastic properties research". From 1986 till present he works as a senior research assistant of system modeling laboratory. Has good skills in written English.

He wrote a monograph "Technology and machines for wire production", published in 2004 by edition house of Russian Academy of Science, Ural Branch. The given monograph was highly evaluated by specialists in the field of wire production at Russian plants and in the countries of countries of ex-URSS. It is also a textbook for university students.

Nowadays scientific research of Dr. Bitkov Vladimir V. is concerned with study of technological possibilities of fine and superfine wire drawing in bunch under hydrodynamic friction conditions for the purpose of getting wire from special alloys and steels with diameter 1 mm and less. To realize pilot research of this study the installation of equipment for fine and superfine wire drawing in bunch in the laboratory is being carried out under his guidance and with his own active participation.

Overall number of works: 21
Major publications:
  • Bitkov V.V., Zalazinsky A.G. Cumulative strain theory for simulation and development of wire drawing. Fatigue & Fracture of Engineering Materials & Structures, 2003, Vol. 26, ¹ 11, p.1033-1039
  • Bitkov V. Mathematical model simulating thin-diameter steel wiredrawing in the presence of back tension. Wire Journal International. September, 2007, p.78-83
  • Bitkov V. Research of wire drawing under conditions of hydrodynamic friction. Wire & Cable Technology International. March/April 2006, p. 94-97
  • Bitkov V., Zalazinsky A. Fine Wire Drawing of Titanium for Suture Material. Wire & Cable Technology International. March/April 2007, p. 42-44
  • V.Bitkov. Composite wire drawing through two dies in one reduction pass. Wire & Cable Technology International, September/October 2007, p.48-51
  • V.Bitkov. Hydrodynamic friction in dies. Wire Industry, May 2007. p.30-38
  • V.Bitkov. Expediency of roller dies application in wire drawing. Part 1. Wire & Cable Technology International, January 2008, p.58-60
  • V.Bitkov. Expediency of roller dies application in wire drawing. Part 2. Wire & Cable Technology International, March 2008, p.112-113
  • Bitkov V.V. Texnologia I mashinu dla proizvodstva provoloki. Ekaterinburg: UrO RAN, 2004, 345 s.
Sphere of scientific interests(keywords): The scientific interests are bound to cold rolling and wire drawing. (Cold rolling, drawing, wire).

UP